143mm Frame Headstock Steering neck Bobber Chopper MACHINED for Harley type cups
Ideal for custom springers into your existing frame or for a complete ground up frame build for other Harley type forks or 1" stem use.
Seamless 50.08mm O.D. tube x 9.53mm wall tube 143mm long
Not a thin wall cheaper offering found on ebay, increasing the risk of structural failure, which may cause splittingof the wall,due to the pressed in cups extra pressure from some over sized cups, after the chrome plating process.
Machined outside diameter.... to maintain concentric.
So inside turning for the bearing cups.... at both ends.... as no cold drawn tube is going to be accurately round or straight
Photo directly above shows Harley Type Headstock Frame to fork adapters fitted
They are not are not supplied with this listing.
Just wanted to illustrate the finished headstock when complete
They are available in our shop, machined to match our supply of chrome cups... ( other brands may NOT fit correctly ) along with taper bearings & dust covers
Be aware that some suppliers cups may not fit correctly... it's your responsibility to determine / adjust the interference fit before pressing into any headstock.... we offer a listing with matched fitting cups.