Kit includes ONE pair of laser cut 10mm thick steel axle plates with sissy bar mountings

As the axle plates are designed for 1" tube.... so a little cutting or grinding may be required

20mm axle slot ( also for 3/4" axles ) or select from the drop down menu your choice, that should give you around 6" axle centre height to bottom of frame. Made from Electric Resistant Welded steel tubing.. similar to your everyday mass produced Honda - Yamaha - Suzuki framework of old. Only ours is probably double the wall thickness at 3.25mm.

For this listing we supply 2 x 1" x 33" top rails.. 2 x 1 1/4" x 26 3/16" bottom rails.. 2 x 12" cross tubes.

These lengths should allow you to trim off to suit your needs ( gives a 31" axle centre to the ends of the top & bottom rails )  and this type of tube will allow minor adjustments to the bend angle to align up with your existing frame, a well fixed vice will be required.

Along with extra tubing if required....combine any length listed with this...to save on delivery cost

Or for any other combination of tubing size mixes...... contact us on 07442 496 186